SMC Networks Barricade SMCWBR14-G User Manual download pdf (Page 16)

Installing the Wireless Barricade g Router

Hardware Description

The Wireless Barricade can be connected to the Internet or to a

remote site using its WAN port. It can be connected directly to

your PC or to a local area network using any of the Fast Ethernet

LAN ports.

Although access speed to the Internet is determined by your

service type and the modem type connected to the Wireless

Barricade, data passing between the devices connected to your

local area network can run up to 100 Mbps over the Fast

Enternet ports.

The Wireless Barricade includes an LED display on the front

panel for system power and port indications that simplifies

installation and network troubleshooting. It also provides four

RJ-45 LAN ports and one RJ-45 WAN port on the rear panel.

• Four Ethernet ports for connection to a 10BASE-T/

100BASE-TX Ethernet Local Area Network (LAN). These

ports can auto-negotiate the operating speed to 10/100 Mbps,

the mode to half/full duplex, and the pin signals to MDI/MDI-X

(i.e., allowing these ports to be connected to any network

device with straight-through cable). These ports can be

connected directly to a PC or to a server equipped with an

Ethernet network interface card, or to a networking device

such as an Ethernet hub or switch.

• One RJ-45 port for connection to a DSL or cable modem

(WAN). This port also auto-negotiates operating speed to

10/100 Mbps, the mode to half/full duplex, and the pin signals

to MDI/MDI-X.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 104 105

No comments

SMC Networks Barricade SMCWBR14-G User Manual Page 16