SMC Networks TigerSwitch 100 User Manual download pdf (Page 146)

OMMAND

INE

NTERFACE

3-2

After connecting to the system through the console port, the login screen

displays:

Telnet Connection

Telnet operates over the IP transport protocol. In this environment, your

management station and any network device you want to manage over the

network must have a valid IP address. Valid IP addresses consist of four

numbers, 0 to 255, separated by periods. Each address consists of a

network portion and host portion. For example, the IP address assigned to

this switch, 10.1.0.1, consists of a network portion (10.1.0) and a host

portion (1).

To access the switch through a Telnet session, you must first set the IP

address for the switch, and set the default gateway if you are managing the

switch from a different IP subnet. For example:

If your corporate network is connected to another network outside your

office or to the Internet, you need to apply for a registered IP address.

However, if you are attached to an isolated network, then you can use any

IP address that matches the network segment to which you are attached.

User Access Verification

Username: admin

Password:

CLI session with the SMC8624T is opened.

To end the CLI session, enter [Exit].

Console#

Console(config)#interface vlan 1

Console(config-if)#ip address 10.1.0.1 255.255.255.0

Console(config-if)#exit

Console(config)#ip default-gateway 10.1.0.254

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 333 334

No comments

SMC Networks TigerSwitch 100 User Manual Page 146