SMC Networks TigerSwitch 100 User Manual download pdf (Page 147)

NTERING

OMMANDS

3-3

After you configure the switch with an IP address, you can open a Telnet

session by performing these steps.

1. From the remote host, enter the Telnet command and the IP address

of the device you want to access.

2. At the prompt, enter the user name and system password. The CLI

will display the “Vty-0#” prompt for the administrator to show that

you are using privileged access mode (i.e., Privileged Exec), or

“Vty-0>” for the guest to show that you are using normal access mode

(i.e., Normal Exec).

3. Enter the necessary commands to complete your desired tasks.

4. When finished, exit the session with the “quit” or “exit” command.

After entering the Telnet command, the login screen displays:

Note: You can open up to four sessions to the device via Telnet.

Entering Commands

This section describes how to enter CLI commands.

Keywords and Arguments

A CLI command is a series of keywords and arguments. Keywords identify

a command, and arguments specify configuration parameters. For

example, in the command “show interfaces status ethernet 1/5,” show

Username: admin

Password:

CLI session with the SMC8624T is opened.

To end the CLI session, enter [Exit].

Vty-0#

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 333 334

No comments

SMC Networks TigerSwitch 100 User Manual Page 147