SMC Networks TigerSwitch 100 User Manual download pdf (Page 71)

100

101

DDRESS

ABLE

ETTINGS

2-41

CLI Configuration

Use the interface command to select the target port, then use the port

security action command to configure the port intrusion action (applies

to all ports). Use the port security command to enable security for the

port.

Address Table Settings

Switches store the addresses for all known devices. This information is

used to route traffic directly between the inbound and outbound ports. All

the addresses learned by monitoring traffic are stored in the dynamic

address table. You can also manually configure static addresses that are

bound to a specific port.

Setting Static Addresses

A static address can be assigned to a specific interface on this switch. Static

addresses are bound to the assigned interface and will not be moved.

When a static address is seen on another interface, the address will be

ignored and will not be written to the address table.

Console(config)#interface ethernet 1/5

Console(config-if)#port security action trap-and-shutdown 3-93

Console(config-if)#port security

Console(config-if)#

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 333 334

Comments to this Manuals

No comments

SMC Networks TigerSwitch 100 User Manual Page 71

Comments to this Manuals

Related products and manuals for Network switches SMC Networks TigerSwitch 100