SMC Networks TigerSwitch 100 User Manual download pdf (Page 70)

100

101

ONFIGURING

THE

WITCH

2-40

Port Security Action

The switch allows you to set the security action to be taken when a port

intrusion is detected. This setting applies to all ports on the switch.

• Shutdown and Trap — Indicates the action to be taken when a port

security violation is detected:

- None: Indicates that no action should be taken. (This is the default.)

- Trap and Shutdown: Indicates that the port is to be disabled and an

SNMP trap message sent.

Web – Click Port, Port Security Action. Specify the security action for a

port intrusion, then click Apply.

Port Security Configuration

On the Port, Port Security Status page, you can enable/disable security for

any switch port. For each port number listed in the “Port” column, you

can configure the following parameter:

• Security Status — Enables or disables port security on the port.

(Default: disabled)

Note: If a port is disabled due to a security violation, it must be manually

re-enabled from the Port/Port Configuration page.

Web – Click Port, Port Security Status. Check the checkbox in the

“Security Status” column to enable security for a port, then click Apply.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 333 334

Comments to this Manuals

No comments

SMC Networks TigerSwitch 100 User Manual Page 70

Comments to this Manuals

Related products and manuals for Network switches SMC Networks TigerSwitch 100